Am 13.08.2014 um 22:40 schrieb Adam Lackorzynski:
So it worked before using DTBs? Some config/setting issue?
Yes, both network of my imx28 worked withou DTB. I is some config issue:
After searching a while, I am sure that the Device Tree is not used in my configuration at all. As I wrote in an older thread "IO configuration language" I am using on the vbus the strings "imx28-fec.mydev0" => wrap(hw-root.NIC0) to get the platform device added in mach_setup.c. This is done by a custom handler in the callbacks which captures the "imx28-fec.mydev0" and "imx28-fec.mydev1" devices and creates the platform device. After renaming the device to "imx28-fec" (and thus disabling the private callback), I see that the device is still added in a generic way (IRQ, MEM, PORT) in copy_platform_device, but without the required additional data (Phy Interface Mode). So Ethernet is still probed but due to the wring mode not working.
Now I removed the strings from the io configuration. Mach_setup.c is no longer adding platform devices and ... Ethernet is no longer probed. I also verified that the DTB was loaded, but for some reasons the DTB is unfortunately not used or does not match.
I am using the imx28-evk.dts where I replaced the "model" and "compatible" line by what I found in simple.dts.
Martin