Hi Ganis Zulfa,You need to setup one ethX for each l4linux.When you start 2 L4Linuxes, you will only see one ethX in current console, becauseyou are connected to the second L4Linux not the first one.It is normal to see only one ethX.One way to setup the ip of first L4Linux is to write the init config in /etc/init.d/rcS.In this case, you need 2 ramdisk for each L4Linux.Here is my config for first L4Linux:# cat /etc/init.d/rcS#! /bin/sh
mount -t proc proc /proc
mount -t devtmpfs devtmpfs /dev
mkdir /dev/pts
mount -t devpts devpts /dev/pts
ifconfig lo up
ifconfig eth0 192.168.50.1
telnetd -l /bin/sh
exit 0For second L4Linux, just change the ip to 192.168.50.2After 2 L4Linuxes start, you will be in second L4Linux(192.168.50.2)then, you can telnet 192.168.50.1 to go to another L4Linux.Cheers,Chao-Jui2013/4/16 Ganis Zulfa Santoso <ganiszulfa@gmail.com>thanks.B. how do i set up the ip of another l4linux arm?Hi Chao-Jui, have u figured out a way to do what Adam said?A. i ran two l4linux arms but i only found one ethX
I followed the instructions from http://wiki.tudos.org/L4Linux/shmnet, but I have problems:
Best regards,
Ganis Zulfa SantosoOn Mon, Apr 8, 2013 at 7:03 AM, Adam Lackorzynski <adam@os.inf.tu-dresden.de> wrote:Hi,
You can connect two L4Linuxes using a l4shmnet-based local network
On Fri Apr 05, 2013 at 13:29:37 +0800, Chao-Jui Chang wrote:
> Is it possible to multiplex multiple text-based console?
> I want to try to start multiple VMs on ARM board which only provides serial
> console.
connection, so you can go from one to the other via e.g. telnet or ssh.
Adam
--
Adam adam@os.inf.tu-dresden.de
Lackorzynski http://os.inf.tu-dresden.de/~adam/
_______________________________________________
l4-hackers mailing list
l4-hackers@os.inf.tu-dresden.de
http://os.inf.tu-dresden.de/mailman/listinfo/l4-hackers