Hi,
On Fri Dec 15, 2017 at 12:09:43 +0000, Sathish Kumar Balasubramaniam -ERS, HCL Tech wrote:
Build machine is Debian 8.10 (jessie) 64-Bit GCC toolchain is gcc-linaro-4.9.4-2017.01-x86_64_arm-linux-gnueabihf I tried to build the l4re-snapshot-17.10 for Freescale iMX6 and the build completed. When i loaded the bootstrap.uimage (both hello and L4Linux-basic) boots till the following
That might just be the wrong UART. The default for imx6 is UART2, which UART is the Wandboard using? You can select the UART by adding PLATFORM_UART_NR=x (for x with 1 to 5) to the command line when building the uimage.
U-Boot 2016.11+fslc+gc44711d (Nov 15 2017 - 16:14:11 +0530)
CPU: Freescale i.MX6Q rev1.2 at 792 MHz Reset cause: POR Board: Wandboard rev C1 I2C: ready DRAM: 2 GiB MMC: FSL_SDHC: 0, FSL_SDHC: 1 *** Warning - bad CRC, using default environment
auto-detected panel HDMI Display: HDMI (1024x768) In: serial Out: serial Err: serial Net: FEC [PRIME] Hit any key to stop autoboot: 0 => ext4load mmc 0 ${loadaddr} /boot/bootstrap.uimage 8790080 bytes read in 628 ms (13.3 MiB/s) => bootm ${loadaddr} ## Booting kernel from Legacy Image at 12000000 ... Image Name: L4 Image #2 Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 8790016 Bytes = 8.4 MiB Load Address: 11000000 Entry Point: 11000000 Verifying Checksum ... OK Loading Kernel Image ... OK
Starting kernel ...
Adam