Hi hackers, Is trustzone working on exynos 4412 platform? I have selected the follow item in Fiasco config menu: * Platform Timer (Multi-core timer) * Use ExtGic * Execution Model (TrustZone normal side) But it stop at early stage. Same result for Execution Model (Standard mode). but no message for Execution Model (TrustZone secure side). If the trustzone is disabled in u-boot, the 'Standard mode' works fine. ----- booting log ----- OK U-Boot 2010.12-00000-g8d816e8-dirty (May 06 2013 - 19:38:10) for Exynox4412 CPU: S5PC220 [Samsung SOC on SMP Platform Base on ARM CortexA9] APLL = 1000MHz, MPLL = 880MHz DRAM: 1023 MiB PMIC VERSION : 0x00, CHIP REV : 3 TrustZone Enabled BSP BL1 version: 20121128 Checking Boot Mode ... SDMMC MMC Device 0: 30959 MB MMC Device 1 not found ModeKey Check... run normal_boot Net: No ethernet found. Hit any key to stop autoboot: 0 Exynos4412 # run fiasco Partition2: Start Address(0x2000), Size(0x1a000) reading bootstrap.raw 835584 bytes read Boot with zImage Starting kernel ... Hello from Startup::stage2 Per_cpu_data_alloc: (orig: 0xf0044588-0xf0044f60) Number of IRQs available at this GIC: 160 ------ end of booting log ----- Best regards, Chao-Jui