Hi, Matthias.

Thank you for answering.

Sorry, I apologize for the late response.

I've configured the NIC driver as follows.. '[*]Network support ' and '[*]Network device driver support'.

I don't know how to init the driver,but when I run 'ifconfig', I saw nothing.

So, I guess that the cause is 'init' could not have been run.
When I've done booting L4Linux, I found '/etc' folder is not enough.
And I found '/proc' and '/sys' is empty.
So, I've manually mounted '/proc' and '/sys'.
And I'm trying to run 'ifup -a' but I've failed secure Ethernet on L4 Linux.

What I mistake ?

(Mentioned above is same as mail before last)

And I'm doubting 'arm-rv.io' and  'l4lx_xs.cfg' I'm using.
Must I modify them ? 

If you give me small hints, I'd apperciate.
Thank you !!

For reference.

I'm using 'entry L4Linux_XS' as follows
========================
entry L4Linux_XS
roottask moe rom/l4lx_xs.cfg
module l4re
module ned
module l4lx_xs.cfg
module io
module arm-rv.io
module vmlinuz.arm
module ramdisk-arm.rd
========================
arm-rv.io in example folder is..
========================
hw-root
{
  NIC => new Device()
  {
    .hid = "smsc911x";
    new-res Mmio(0x4e000000 .. 0x4e000fff);
    new-res Irq(60);
  }
}

l4lx => new System_bus()
{
  NIC => wrap(hw-root.NIC);
} 
========================
l4lx_xs.cfg is ..
========================
-- vim:set ft=lua:

local lxname = "vmlinuz";
if L4.Info.arch() == "arm" then
  lxname = "vmlinuz.arm";
end

L4.default_loader:start(
  { caps = {
      log = L4.Env.log:m("rws"),
    },
    l4re_dbg = L4.Dbg.Warn,
    log = { "l4linux", "yellow" },
  },
  "rom/" .. lxname .. " mem=64M console=ttyLv0 l4x_rd=rom/ramdisk-" ..  L4.Info.arch() .. ".rd root=1:0 ramdisk_size=4000 init=/bin/sh");
========================

- Taeung -

On 04/18/2014 09:21 PM, Matthias Lange wrote:

Hi,

On 18.04.2014, at 13:24, Taeung <treeze.taeung@gmail.com> wrote:

Hello, Adam and L4 Hackers.
Thanks for answering.

When I run 'ifconfig', nothing have happened.
I guess that the cause is /etc folder in ramdisk is not enough to run 'init'. 

Would you mind if I ask you another question ? 

Must also I modify 'arm-rv.io' ? 
or must I modify 'l4lx_xs.cfg' ? 
or Do not I need do it ? 

If I have to modify them , how to modify  ? 
(I'm using Freescale imx6q SABRE SD board.)

If you give a bit me hints, I'd appreciate.

Do you have configured the NIC driver into L4Linux? Do you see L4Linux trying to init the driver. I fear your questions are to generic to give a specific answer.

Matthias.

--

matthias.lange@kernkonzept.com - Tel. 0351-41 888 614

Kernkonzept GmbH.  Sitz: Dresden.  Amtsgericht Dresden, HRB 31129.
Geschäftsführer: Dr.-Ing. Michael Hohmuth