Hi,
On Mon Aug 17, 2020 at 22:35:11 -0700, Andreas Steinmetzler wrote:
Hi,
I'm experimenting with the TuD Snapshot release 2020.07.1 and can compile and run Fiasco, L4re and L4Linux in their basic configurations (amd64 architecture) using the default l4lx.cfg file of the distribution.
As this is not all that useful, I was looking in getting the system use the available hardware. Based on snippets I found on the internet and the example config files, I created the following cfg and devs files, but now L4Linux immediately runs into an unhandled exception (full boot log at the end of this eMail).
Was wondering if someone from the mailing list can share a set of config files which would allow to get L4Linux up and using at least some of the basic hardware like network and disks on a typical PC board. In my current experiments I'm using the following config files (see below).
Any help or pointers are appreciated!
An error like this should not happen, irrespective of any config. I've uploaded 2020.08.0 and checked that the amd64 L4Linux configs in the L4Linux-mag setup works and sees PCI devices. Could you work from that config?
Adam