Hi, Matthias.
Thank you for answering.
Sorry, I apologize for the late response.
I've configured the NIC driver as follows.. '[*]Network support '
and '[*]Network device driver support'.
I don't know how to init the driver,but when I run 'ifconfig', I saw
nothing.
So, I guess that the cause is 'init' could not have been run.
When I've done booting L4Linux, I found '/etc' folder is not enough.
And I found '/proc' and '/sys' is empty.
So, I've manually mounted '/proc' and '/sys'.
And I'm trying to run 'ifup -a' but I've failed secure Ethernet on
L4 Linux.
What I mistake ?
(Mentioned above is same as mail before last)
And I'm doubting 'arm-rv.io' and 'l4lx_xs.cfg' I'm using.
Must I modify them ?
If you give me small hints, I'd apperciate.
Thank you !!
For reference.
I'm using 'entry L4Linux_XS' as follows
========================
entry L4Linux_XS
roottask moe rom/l4lx_xs.cfg
module l4re
module ned
module l4lx_xs.cfg
module io
module arm-rv.io
module vmlinuz.arm
module ramdisk-arm.rd
========================
arm-rv.io in example folder is..
========================
hw-root
{
NIC => new Device()
{
.hid = "smsc911x";
new-res Mmio(0x4e000000 .. 0x4e000fff);
new-res Irq(60);
}
}
l4lx => new System_bus()
{
NIC => wrap(hw-root.NIC);
}
========================
l4lx_xs.cfg is ..
========================
-- vim:set ft=lua:
local lxname = "vmlinuz";
if L4.Info.arch() == "arm" then
lxname = "vmlinuz.arm";
end
L4.default_loader:start(
{ caps = {
log = L4.Env.log:m("rws"),
},
l4re_dbg = L4.Dbg.Warn,
log = { "l4linux", "yellow" },
},
"rom/" .. lxname .. " mem=64M console=ttyLv0 l4x_rd=rom/ramdisk-" .. L4.Info.arch() .. ".rd root=1:0 ramdisk_size=4000 init=/bin/sh");
========================
- Taeung -
On 04/18/2014 09:21 PM, Matthias Lange
wrote:
Hi,
Hello, Adam and L4 Hackers.
Thanks for answering.
When I run 'ifconfig', nothing have happened.
I guess that the cause is /etc folder in ramdisk is not enough to run 'init'.
Would you mind if I ask you another question ?
Must also I modify 'arm-rv.io' ?
or must I modify 'l4lx_xs.cfg' ?
or Do not I need do it ?
If I have to modify them , how to modify ?
(I'm using Freescale imx6q SABRE SD board.)
If you give a bit me hints, I'd appreciate.
Do you have configured the NIC driver into L4Linux? Do
you see L4Linux trying to init the driver. I fear your
questions are to generic to give a specific answer.
Matthias.
--
matthias.lange@kernkonzept.com -
Tel. 0351-41 888 614
Kernkonzept GmbH. Sitz: Dresden. Amtsgericht Dresden, HRB
31129.
Geschäftsführer: Dr.-Ing. Michael Hohmuth